Firmware updates#

Board keeps BrainAccess headsets up to date. It checks for new headset firmware when it starts and whenever a headset connects (this needs an internet connection), and offers an update only when one is published for your headset.

Which firmware your headset gets#

Board reads which board your headset is built on from the headset itself and offers the firmware made for that board: HALO (second and third generation), MINI, MIDI, MAXI and EXG8 each have their own. First-generation HALO headsets are not offered firmware updates in Board.

Updating#

Before you start:

  • Charge the headset above 40 %. Board refuses to start below that.

  • Stop any recording from this headset. It stops streaming during the update.

  • Keep the headset close to the computer and switched on.

Then:

  1. Connect the headset (see Connect). If newer firmware is available, its card in Connected Devices shows an orange FW ↑ badge. Hover it to see the versions.

  2. Click FW ↑. The Firmware Update window shows Device firmware (installed now) and Available (the update).

  3. Click Start Firmware Update. The card shows a progress bar, “Transferring firmware…”. The transfer takes about one and a half minutes; don’t switch the headset off or carry it away.

  4. When the transfer ends, the headset installs the firmware and restarts switched off, so it leaves Connected Devices. A banner at the top of the window says “… firmware transfer finished and the device restarted switched off. Long-press it to switch it on, then connect it to confirm the update to …”.

  5. Long-press the headset’s power button to switch it on, then connect it again from the BrainAccess card.

  6. Board reads the installed version. The banner changes to “… updated to firmware …”, and the FW ↑ badge is gone. Click OK to close the banner.

If the banner instead says “… still reports firmware …: the update to … did not install”, the headset kept its previous firmware. Click FW ↑ on its card to try again.

Headsets with firmware 3.6.0 drop the Bluetooth link at the very end of the transfer. That is expected and not an error; the version the headset reports after step 5 tells whether the update worked.

If an update fails#

A failed update shows a red Retry badge on the device card. Hover it, or open it, for the reason:

Message

What to do

Battery too low — charge the device above 40% and retry.

Charge the headset, then click Retry Firmware Update.

Couldn’t download firmware — check the internet connection and retry.

Board could not fetch the firmware or the file was damaged on the way. Check the connection and retry.

Device rejected the firmware image — it keeps its current firmware.

The headset refused the file and still works on its old firmware. Contact support if it happens again.

No firmware is published for this device model yet.

Nothing to install for this headset.

The device dropped the link at the end of the update …

Usually the update worked (see step 4). Switch the headset on and connect it; the banner tells the result.

Older Board versions#

After a headset is updated to firmware 3.8.7, Board 3.0 and earlier can still connect to it but can no longer stream from it. Update Board on every computer that uses the headset (Resources → Downloads) before or right after updating the headset’s firmware.