Device templates#

A template is the recording preset for a device: which channels it has, what they are called, the sample rate, and per-channel hardware settings. Board ships templates for every BrainAccess device (HALO, MINI, MIDI, MAXI) and for the synthetic generators; you can adjust them or create your own.

Where to edit: on the Connect screen, click the gear icon on a device card to open its template editor. Templates are stored as files you can back up or copy between machines — the Templates card on the Folders screen opens their folder.

BrainAccess device templates#

The editor shows the device-wide settings and a per-channel table.

Device-wide:

Setting

Meaning

Reference

The reference electrode (default Fp1; HALO Fpz). All channels are measured against it.

Ground

The ground (bias) electrode (default Fp2; HALO Fpz). Recorded with the data and published in the LSL stream; it does not change the device settings.

Sample Rate (Hz)

Samples per second. If the device supports only one rate it is shown as a fixed label; otherwise pick from the supported rates.

Per-channel table:

Column

Meaning

Pin

The physical connector pin on the device.

Channel

The channel name — standard 10–20 electrode names (Fp1, F3, Cz, O2, …). The picker has a “Type to filter…” box.

Active

Whether this channel is streamed and recorded. Switch unused channels off.

Bias

Whether this channel participates in the device’s noise-cancelling bias circuit.

Gain

The amplifier gain for this channel.

Name your channels to match where the electrodes actually sit — the viewer uses the names for channel ordering and display.

The template file also describes the cap and electrodes — cap manufacturer and model, electrode coupling and material, and which electrodes are forehead pads (cap_manufacturer, cap_model, electrode_coupling, electrode_material, electrode_pad_channels). They are not shown in the editor; edit the file only if you use a different cap. Board publishes them in the device’s LSL stream (see LSL contract (v1)).

Synthetic templates#

Templates for the Synthetic Data generators have their own per-channel table: Channel, Active, Function (the waveform), Freq (Hz), Amplitude, and Phase. Adjust these to shape the test signal each channel produces.

Tips#

  • Changes apply the next time you connect the device.

  • To share a setup, copy the template file from Folders → Templates to the same folder on another machine.

  • If you mainly want to check electrode contact, you don’t need to edit templates — use Impedance mode on the Connect screen instead (see Connect).