OutputMode

What the device streams on its EEG channels — the one-byte value of the output-mode characteristic (GattUuids.OUTPUT_MODE_CHARACTERISTIC); codes are the wire contract, matching the vendor C SDK's output_mode.h. Firmware 3.7.0 and later expose the characteristic; older firmware has none and always streams NORMAL.

The device applies the value at the next stream start and keeps it until it is power-cycled — across stream restarts and reconnects, whoever wrote it — so a host that wants electrode data must write NORMAL explicitly rather than rely on a default.

Entries

Link copied to clipboard

Electrode measurements (the default).

Link copied to clipboard

The ADS1299's internal test signal on every channel instead of the electrodes: a square wave of 3.74 mV peak-to-peak (±1.87 mV) at about 1 Hz, input-referred — the same µV at every gain, which makes it a check of the whole scaling chain (measured on the EXG8 board, fw 3.7.0).

Properties

Link copied to clipboard
val code: Byte
Link copied to clipboard

Returns a representation of an immutable list of all enum entries, in the order they're declared.

Link copied to clipboard
Link copied to clipboard

Functions

Link copied to clipboard

Returns the enum constant of this type with the specified name. The string must match exactly an identifier used to declare an enum constant in this type. (Extraneous whitespace characters are not permitted.)

Link copied to clipboard

Returns an array containing the constants of this enum type, in the order they're declared.