Troubleshooting#

Common symptoms and what to try, grouped by what you see. Each section keeps the fix short and specific.

No headsets found#

Headset switched on and charged? Bluetooth on? Did you grant Bluetooth access to BrainAccess Mobile in iOS Settings? Move within a couple of metres and tap Scan again. A headset already connected to another phone or BrainAccess Board will not appear.

Connects, then drops#

Keep the iPhone within a few metres and avoid putting your body between the device and headset. Charge both. Repeated N samples lost messages normally mean link congestion — close other Bluetooth-heavy apps and avoid scanning while streaming.

All electrodes red or “No contact”#

Seat the reference/ground electrode first, then press each electrode down and part the hair. For dry electrodes give the skin a few seconds to settle. Use the contact check before every session.

Strong 50/60 Hz hum#

Check the reference/ground electrode, unplug the phone charger, move away from mains cables and power supplies, and confirm the notch frequency matches your country (50 Hz in most of the world, 60 Hz in North America).

Traces look flat#

Electrodes with no contact are deliberately flattened. Check the quality dots and the contact check. Also check Scale and Sensitivity in More.

LSL stream not visible on the computer#

LSL streaming is not available in BrainAccess Mobile 1.0.0: the LSL outlet switch is greyed out and the app does not publish a stream. To get the signal onto a computer, record in the app and share the file (see Files, storage and privacy).

Recording stops by itself#

Check free storage, then whether the headset went out of range. Disconnecting or an OTA update also ends a recording. If the screen was off or the app was in the background, iOS may have suspended or terminated the session; keep the app in the foreground for recordings that must not be interrupted (see Installation).

Cannot find recordings in Files#

Use the in-app Recordings browser and Share / Save to Files. Local recordings are inside the app container, excluded from backup, and deleted when the app is uninstalled unless you export them first.

Firmware update stuck or failed#

Keep the app foregrounded, charge the headset to at least 30% or plug it in, keep the headset nearby, and retry only after reading the exact error. A checksum mismatch means the image was rejected and was not installed; try again later or contact support.